 |
Raspberry Pi's health is at risk |
| This is not a drill! A red icon indicates a current issue, a yellow one that was observed since the device booted up |
←
|
Undervoltage detected |
| Make sure your power supply and cabling are providing enough power to the Raspberry Pi (3A minimum) |
|
Overheating detected |
| Frequency capping due to overheating, please improve cooling of the Raspberry Pi |
|
Raspberry Pi's health is at risk |
| This is not a drill! A red icon indicates a current issue, a yellow one that was observed in the past |
|
Fan failed |
| A fan error occured, please check the log |
System
| Runtime settings & tools |
|
WebRTC is not supported by this browser |
|
Direct H.264 streaming is not supported |
|
H.264 is not supported by this browser |
| Resolution: | ||
| JPEG quality: | ||
| JPEG max fps: | ||
| H.264 kbps: | ||
| H.264 gop: | ||
| Video mode: |
|
|
| Orientation: |
|
|
| Audio volume: | ||
| Microphone: |
|
| Keyboard mode: | |
| Mouse mode: | |
| Shortcuts magic: |
Keyboard & mouse (HID) settings
| Swap Left Ctrl and Caps keys: |
|
| Mouse polling: | ||||||
| Relative sensitivity: | ||||||
| Squash relative moves: |
|
|||||
| Reverse scrolling: |
|
|||||
| Cumulative scrolling: |
|
|||||
| Scroll rate: | ||||||
| Show the blue dot: |
|
Web UI settings
| Ask page close confirmation: |
|
| Expand for the entire tab by default: |
|
| Suspend stream when tab is not active: |
|
| Bad link mode (release keys immediately): |
|
| Connect HID to Server: |
|
| Mouse jiggler: |
|
| Mute all input HID events: |
|
| Connect main USB to Server: |
|
| Enable locator LED: |
|
ATX
Drive
Mass Storage Drive:
|
Mass Storage Drive is offline |
|
Current image is broken! |
| Perhaps uploading was interrupted |
|
Current image is too big for DVD! |
| The maximum is 31.6GiB. Please switch to the Flash mode. |
|
Current image is out of storage |
| This image was connected manually using kvmd-otgmsd |
|
Read-write mode is enabled |
| Do not turn off PiKVM while this is active to prevent filesystem corruption. Use read-only mode where possible, as writing to SD card often can reduce its lifespan. |
 |
The image is being downloaded from PiKVM |
| Please wait |
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Image: | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Drive mode: |
|
Writable: |
|
|
Another user uploads an image |
| Specify a local file: | |
| Or paste a URL: | |
| Upload partition: |
| New image: | |
| Upload size: |
| Note: | • Don't close the browser page until the upload is complete. |
| • To speed up the upload, close the stream window. |
Macro
Text
Switch
|
PiKVM Switch is attached
Select a port or perform any available action like ATX click |
|
|
Good news! Your switch is ready to get the firmware update |
| Please follow the instructions when you decide to install it. |
| Ask ATX click confirmation: |
|
| Confirm switching when the Drive is connected: |
|
